fbpx
Print this page
Thursday, 27 September 2018 11:32

Landboss’ power lets you know who’s in charge

Written by  Mark Daniel
Landboss has plenty of power. Landboss has plenty of power.

We looked briefly at the Landboss in October 2017, but more recently spent a week driving the latest version onfarm in Waikato just as spring showed its hand. 

Marketed in New Zealand by Mojo Motorcycles who also sell the CF Moto brand, the Landboss grabs attention with its power plant -- a naturally aspirated, 3-cylinder, Perkins 400 series diesel.

Especially on a single-fuel farm, the main benefit would be the ‘sniffs of an oily rag’ on which this thrifty beast runs.

And although the Landboss only rates about 20hp on paper, it still has plenty of pulling power, lots of go and hits its modest top speed of 50km/h quickly. 

Service intervals are a very agricultural 500 hours, while a 2-year factory warranty can only serve to enhance the ownership experience.

Stepping into the operator station you see a wide bench seat with room enough, and seatbelts, for three large adults. For the driver, an adjustable steering column makes for a comfortable fit, while electric power steering takes the strain out of manoeuvring. 

To the drivers left, a conventional handbrake with a warning light sits at the end of the bench, while the gear selector sits to the left of the dashboard. The lever allows the choice of high, low, neutral and reverse, with selection smooth, positive and with little resistance.

The Perkins diesel is mated to a Canadian CV Tech transmission that is quiet in operation and builds up speed in a smooth linear manner, while being complemented by the choice of 2WD, 4WD (with front and rear locking differentials) plus the addition of turf mode that will be a bonus if you decide to take a shortcut across the lawn.

The operator station has ‘boot guards’ to keep feet inside the safety zone of the ROPS-certified roll frame, a full windscreen with wash/wipe, composite roof and a 3000lb electric winch mounted under the front bull bar assembly. 

The driver is well informed by a central digital display for all key parameters, although the choice of grey on grey means it is difficult to see in bright sunshine.

Stopping the 700kg machine falls to dual discs up front and a single disc at the rear, while suspension takes the form of dual A-arms with coil springs over shocks. Ground clearance is 280mm.

The ride is smooth and comfortable, with the adjustable suspension absorbing most of the bumps on a Waikato dairy farm. 

As with any vehicle of this type, fetching and carrying is important, so a 400kg capacity for the bed and 680kg at the heavy-duty drawbar looks a workmanlike figure. The load platform has useful dimensions, with drop-down sides and tailgate adding to the versatility, while a decent overhang beyond the rear pivots allows heavy loads to be tipped manually with ease.

Add standard equipment such as mudflaps, a comprehensive lighting package, head restraints and rear-view mirror, then this UTV is worth a closer look.

More like this

Bigfoot comes up trumps

Call them what you will, but UTVs, or side-by-sides, have certainly found a place in much of New Zealand’s rural sector.

No wild ride!

Honda's Pioneer UTV range has a huge following on the farms and back blocks of New Zealand.

OPD argument raging on

A stoush is brewing with the Federal Chamber of Automotive Industries (FCAI) heavily criticising Farmsafe Australia’s recent Safer Farm Report.

Featured

National

Green but not much grass!

Dairy farmers in the lower North Island are working on protecting next season, according to Federated Farmers dairy chair Richard…

Council lifeline for A&P Show

Christchurch City Council and the Canterbury Agricultural and Pastoral Association (CAPA) have signed an agreement which will open more of…

Struggling? Give us a call

ASB head of rural banking Aidan Gent is encouraging farmers to speak to their banks when they are struggling.

Machinery & Products

Tractor, harvester IT comes of age

Over the last halfdecade, digital technology has appeared to be the “must-have” for tractor and machinery companies, who believe that…